Temperature Sensors with Unified Output TSPU-303p TSMU-303p

Temperature sensors with a unified output TSPU-303p, TSMU-303p or Universal Temperature Transmitters (PTU) are intended for measuring temperature and converting the measured value into a 4..20 mA, 0..10 V, or RS-485 signal. 303p temperature sensors are used for measuring ambient temperature, liquid, gaseous and bulk media temperatures in various industries where the ambient temperature does not exceed 85 °C. Structurally, temperature sensors with a unified output TSPU-303p, TSMU-303p are 303p type sensors with a built-in conversion board outputting a 4..20 mA, 0..10 V signal or an RS-485 interface with the ModBus RTU communication protocol. Universal Temperature Transmitters are intended for: Converting resistance value into a current signal (4..20 mA) proportional to the temperature value; Converting resistance value into a voltage signal (0..10 V) proportional to the temperature value; Measuring and transmitting the measured temperature value via RS-485 interface (protocol ModBus RTU). Main characteristics of temperature sensors with unified output TSPU-303P, TSMU-303P Measured temperature range — from -40 to 270 °C; Minimum mounting part length — 80 mm; Powered from a 24 V DC power supply; Voltage output converters (0..10 V) are manufactured only in Z-65 housing; RS-485 signal converters are manufactured in G302 housing; Tolerance classes of the sensitive element installed in the temperature sensor — 1 / 3B (for resistance thermometers TSP), A, B, C (for TSM and TSP), 1 and 2 (for thermocouples TXA, TXK, TJK); Design of resistance thermometers — non-disassemblable; Insulation resistance — not less than 100 MOhm. Temperature sensors with unified output signal can be manufactured with mounting lengths from 80 to 3000 mm, diameters from 4 to 16 mm. For installation locations where ambient air temperature is below 85 °C, temperature sensors with unified output signal with a terminal head made of high-temperature press material can be used, for example, type 001 (temperature up to 270 °C) or duralumin (temperature up to 350 °C). In this case, the converter board should be used in a separate housing.